Many people have never heard of shower valve plumbing tips. Most are familiar with the general plumbing terms like lay-pipe, freestanding or tub-style plumbing. There is also a plumbing term called T-back, which is the cross connection of two PEX pipe connections. They look like little bolts that connect the ends of each pipe. When you water your shower, water is first released from the top of the piping and goes down the pipe at the bottom. The drain of the shower is usually on the bottom.
T-backs are different than regular PEX pipes in that they use a T-shaped connector that can be bent into various shapes and bends to help with drainage problems. For DIYers, PEX usually is the easiest kind of plumbing to install. Making the connections necessary for shower valves usually takes the use of a torch to thread the piping, making sure it’s a proper fit in both holes of the shower stall and then make the seals needed. New shower valve plumbing is installed using flexible plastic Macias with threaded brass pipe seals.
The T-back was designed to increase water flow and reduce losses from the water supply line. It also allows for some headroom, so it can be easily installed. It’s easy to find PEX plumbing kits that include this connector along with the bent ends that will hold the T-back in place. Some shower fixtures include this special curved male pipe fittings so they can be easily joined without the aid of special tools.
When you’re preparing to go about installing your shower valve plumbing, remember that the installation is not one that should take very long. The instructions will be clearly listed so you can follow along easily. You may want to go through the whole guide with a pen to make sure you have all of the supplies and materials you need. Be sure to read the entire section on the products you’re going to need carefully before you begin.
Be sure you understand exactly what each part of the plumbing is for. For example, you’ll need to have at least one flexible pipe for the water supply as well as two or more bendable male pipes for connecting the T-back and the airstream. In addition to the pipes, you will need to complete one or two attachments depending on what type of shower you are purchasing. There are numerous different attachments available.
The first thing you want to do before starting the installation process is to install your bending tubes. These are necessary so you can install your shower valve on the underside of the existing drain plumbing. Be sure to mark the bends on the tubes so you can easily install them afterwards. Once you have done this, you can begin the installation of the shower valves. Your local plumber will be able to help you with this if you would like.
When you have the plumbing installed properly, you can then install the T-back to your existing plumbing. This allows for your shower valves to keep a good seal with the walls of the showering area. Next, you can install the stainless steel pipes that extend from the shower unit to the rest of the house. These pipes are also available in various different configurations. You just have to ensure that they are installed properly to ensure that your showering area has the best flow of water possible.
Installing CPVC pipe fittings is a very straightforward process. Many people choose to go with this route simply because of the simplicity of the process. When you hire someone to do the plumbing, they can help you through the whole process so that you don’t end up paying for labor that you don’t want.